+- Sitni Sati Forums (https://forum.afterworks.com)
+-- Forum: Products (https://forum.afterworks.com/forumdisplay.php?fid=4)
+--- Forum: FumeFX [max] (https://forum.afterworks.com/forumdisplay.php?fid=8)
+--- Thread: Getting rid of hemispherical smoke heads? (/showthread.php?tid=382)
Getting rid of hemispherical smoke heads? - emil_vfx - 07-13-2007
Hello evreyone!
I simulate some smoke being blown out of a tube, using the Simple Src. Unfortunatelly I alwas have these typical hemispherical mushroom-alike heads in front of the smoke stuff itself and I cannot get rid of it despite all the tweaking. How can I remove that?
Thank you!
Greets
Emil
Re: Getting rid of hemispherical smoke heads? - sitnisati - 07-13-2007
Hello,
You can try to put a bigger source behind original, that will only serve to create wind and initiate some motion in the grid.
Tricks like that should make a difference.
Regards,
Kresimir
Re: Getting rid of hemispherical smoke heads? - milwatt - 08-13-2007
If I've understood your problem, you can also animate the emission from the source.
In fact, I think the temperature is the cause of that initial mushroom shape.
Animate on a few frames the smoke density from 0 to your desired value, and do the same for the temperature.
Milwatt