06-23-2019, 01:18 AM
More information: I had to force quite Cinema after I sent this file. I then reloaded the file, and it now appears to work. You might be able to see the result if you run the sim on the file as well. This time around, it shows no error in the window.
I do have an explanation for this: I created the turbine blades from the cone emitter geometry, using a couple of deformers. I saved a copy of that result by the "Current State to Object" command, and proceeded to run the sim. However, I had neglected to disable the deformers, etc. before doing so. I think the sim had hung at that point, though I did not realize it. When I tried to run the sim again is when I noticed the error code.
Cinema continued to operate normally, though it would not let me shut it down. I had to do that via the Task Manager force quit command.
I do have an explanation for this: I created the turbine blades from the cone emitter geometry, using a couple of deformers. I saved a copy of that result by the "Current State to Object" command, and proceeded to run the sim. However, I had neglected to disable the deformers, etc. before doing so. I think the sim had hung at that point, though I did not realize it. When I tried to run the sim again is when I noticed the error code.
Cinema continued to operate normally, though it would not let me shut it down. I had to do that via the Task Manager force quit command.