01-05-2007, 06:27 PM
Hello,
I am using Fume to sim movement, then P flow to create parts.
but ...
p Flow follow op is not getting very accurate results. (parts moving at near 1/2 speed with little shape.
It seems as i increased the rate of movement in fume, i got much worse results.
I had much more accurate results with other setups, including earlier versions of the current set up I am working on.
any ideas
I am using Fume to sim movement, then P flow to create parts.
but ...
p Flow follow op is not getting very accurate results. (parts moving at near 1/2 speed with little shape.
It seems as i increased the rate of movement in fume, i got much worse results.
I had much more accurate results with other setups, including earlier versions of the current set up I am working on.
any ideas
sam